ACEC Trailer Mounted Foam Unit, Self Contained using separate engine drivers for Sullair 900-1500 cfm Compressor and Ariel JGQ/2 Booster with maximum discharge pressure from 2000 with 350 PSIG Sullair and 2550 PSIG with 500 PSIG Sullair. Your choice of engines Caterpillar or Detroit Diesel Electronic 4 cycle Engines.

Compressor Capacity and Operating Conditions

1. Gas (by volume)- Air
2. Inlet Pressure- 14.7 psig
3. Inlet Temperature- 120 F
4. Discharge Pressure- 350-500 psig
5. Compressor brake horsepower with cooling fans- 400-665 bhp
6. Engine output speed- 2100 rpm
7. Compressor input speed- 2100 rpm
8. Flow Capacity- 900-1500 cfm

Booster Capacity and Operating Conditions

1. Gas (by Volume)- Air
2. Inlet Pressure- 350-500 psig
3. Inlet temperature- 120 R
4. Discharge Pressure- 2000-2550 psig
5. Booster brake Horsepower- 200-280 bhp
6. Cooling Fan Brake Horsepower- 15 bhp
7. Compressor input Speed- 1800 rpm
8. Capacity/Volume- 900-1500 scfm

Pump Capacity and Operating Condition

1. Fluid (by volume)- Water
2. Inlet Pressure- Gravity
3. Inlet temperature- 120 F
4. Discharge Pressure- 2000-3500 psig
5. Pump brake horsepower- 65max bhp
6. Pump Speed- 100-500 rpm
7. Capacity- 6-50 gpm

Scope of Supply

1. Sullair Two Stage 900-1500 cfm, Lubricated oil flooded, gear drive , 2100 rpm input speed compressor assembly flywheel mounted, direct drive with a rubber drive coupling.
2. Ariel Single Stage JGQ/2 Air Cooled Double Acting Horizontal opposed, Air Booster, 1800 rpm input speed, direct drive with a woods steel pack flexible coupling, Oversize with 1.5 service factor.
3. KERR KP-3300-XP Triplex continuous Duty Plunger Pump. With 1 1/4" – 2" Plungers with a 4.8 to 1 Pinion Drive with U-Joint from 4 Speed Transmission and Manual Hand Clutch and Throttle.
4. Caterpillar or Detroit Diesel Electronic Engines, rated up to 665 bhp @ 2100 rpm, driving the Sullair, Caterpillar or Detroit Diesel Electronic engine, rated up to 325 bhp @ 1800 driving the Ariel JGQ/2 Booster, both four cycle Electronic engines.
5. Caterpillar, Cummins or Detroit Diesel, four cycle mechanical diesel engine, rated up to 100 bhp @ 2200 rpm, driving the Kerr KP-3300-XP thru a 4 speed transmission.
6. ACEC designed and fabricated weather tight, Control Panel Stainless Steel construction, vibration isolated, with Engine Electronic Display Module in front panel to provide instant readout of all engine temperatures and pressures, percent of load, fuel used and active and non active engine diagnostic codes, analog style gauges for all compressor, booster and mist pump temperatures and pressures. Halliburton MC-II Flow meter for Mist Pump Flow Rate.
7. Compressor Cooler assembly is a Mesabi designed with field repairable tubes, driven off of the PTO from Sullair Air End for Oil Cooler and Air aftercooler. Engine jacket water and Charge Air Circuit for compressor is a separate unit driven off the front of the 60 Series Detroit. Booster Cooler is a tube and fine designed Fin-X for engine jacket water, engine charge air circuit, booster intercooler and aftercooler driven off of the front of the series 50 Detroit crankshaft.
8. Vertical Style ASME Coded Vertical Suction Moisture scrubber with internal stainless steel demister with manual drain valves for each stage of booster.
9. 2 " schedule 80 piping from Sullair discharge through to the final discharge of booster aftercooler.
10. Unit will have two TexSteam or Optional CheckPoint full Stainless Steel injection pumps and one Hydraulic driven 3" Roper style transfer pump, mounted and piped to customer's specifications.
11. ACEC Designed tandem drop deck Trailer built by Great Dane Mfg. with 34,000# axles, air brakes, steel radial tires 45 ' long X 102" wide meets or exceeds all D.O.T. specifications. Hydraulic legs with sand pads and stiff legs for pinning. Hydraulic system driven off of Mist Pump transmission with PTO cable to disengage when not needed.
12. One 1000-1500 Gallon 7 Gauge Fuel Tank with seven internal baffles & visual level indicator. One 34 barrel Mist Tank with dividers for valving off when needed. Two 120 gallon Stainless Steel Chemical tanks with isolating valves and visual indicators mounted under side rails of trailer.
13. Painted with primer coat and polyurethane top coat customer color choice.
14. Two sets of Manufactures operation, maintenance, parts and recommended manual supplied with unit for each component, extra copies available on request.

Weights and dimensions (approximate)

1. 56,500 #
2. 45' long X 102" wide X 120" high

 Delivery

1. FOB Fort Smith, Arkansas
2. Normal Lead time from in stock to 10-16 weeks